Ratoc FR1SX Betriebsanweisung PDF herunterladen (Seite 17)

Macintosh

(6)B’sCrew SIM FireREX1 file is copied in the [Extensions] folder.

This B’sCrew SIM FireREX1 is enabled.

Only when you want to use the devices/software((1)-(4)) described in Page 12,

you must set the B’sCrew SIM FireREX1 enabled(The B’sCrew SIM

FireREX1 is set enable when this driver has been installed). If you don’t use

the devices/software((1)-(4)), set the B’sCrew SIM FireREX1 disabled with

the [Extensions Manager]. If you set B’sCrew SIM FireREX1 disabled,

you can use the FR1SX to recognize a SCSI device as a FireWire device.

Here is the explanations of how to use B’sCrew SIM driver:

(1)Example 1

If you want to use a SCSI Scanner with the FR1SX and will not use any

other devices, FireWire Hot Swapping, Plug and Play, please refer to the

following steps.

A.The SIM Driver mode on FR1SX firmware operating mode must be set

enable(Default setting is enable).

B.The B’sCrew SIM driver must be set enable.

C.Turn off your Mac and hook up the FR1SX/Scanner to a FireWire port.

D.Turn on the Scanner. Please make sure the green LED of the FR1SX

comes on. If not, please check the Term-Power at the scanner SCSI

connector. Refer to Chapter 5-4 for more information.

E.Turn on your Mac.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

Keine Kommentare

Ratoc FR1SX Betriebsanweisung Seite 17